Names Of Parts - Kyocera DU-21 Manual Del Usuario

Names of parts

Before installing the duplexer, please read the following list of names. These
names are used in describing procedures for installing and using the duplexer.
See Figure 1 on page iii.
Connector: When you install the duplexer, this connector plugs into a connector
located inside the bottom of the printer (or of the optional paper feeder, if used
together with the duplexer).
Positioning pins: These pins fit into two holes in the bottom of the printer (or
of the optional paper feeder, if used together with the duplexer).
READY indicator: Lights when the duplexer is ready. Flashes when a jam
occurs in the duplexer.
Duplexer drawer: Open to install the paper path adaptor, or to clear paper jams.
Rear cover: Opens to allow clearing paper jams.
5