Fitting.the.front.wheel - Magura TS8 Manual De Instrucciones

f
itting tHe frOnt wHeel
Danger of accident due to front wheel blocking because of faulty instal-
lation work.
Make.sure.that.a.minimum.gap.of.at.2.mm.exists.between.rotating.
Î –
parts.(hub,.fastening.screws.on.the.disc.brake.rotor,.etc.).and.the.
. s uspension.fork..Replace.the.parts.if.needed.
Make.sure.that.the.brake.cable.can.never.touch.the.tire.
Î –
Make.sure.that,.when.fully.depressed,.your.suspension.fork.has.a.
Î –
. m inimum.clearance.of.6.mm.between.the.tire.and.the.crown..Replace.
the.tire.if.needed.
Make.sure.that.the.front.wheel.brake.system.is.correctly.fitted.and.
Î –
adjusted.
Danger of accident due to quick release system failure due to impair-
ment through soiling.
Whenever.you.install.the.front.wheel,.make.sure.that.the.dropouts.on.
Î –
your.suspension.fork.and.all.the.parts.of.your.quick.release.system.are.
clean.
Danger of accident due to faulty installation work.
MAGURA.suspension.forks.with.dropouts.for.thru.axle.(PM.7").. m ust.be.
Î –
combined.exclusively.with.the.MAGURA.M15.thru.axle.clamping.system.
Make.sure.that.the.dimensions.and.type.of.the.front.wheel.hub,.wheel,.
) .
tires,.quick.release.system.and.disc.brake.rotor.match.your.suspension.
fork.– see. ,.page.23.
t s
ecHnical pecificatiOns
If.applicable.mount.the.disc.brake.rotor.on.the.front.wheel.hub.
) .
... using traditional quick release skewer
Danger of injury on sharp and/or hot disc brake rotor when removing
the front wheel.
Always.mount.the.clamping.lever.on.the.front.wheel.quick.release.on.
Î –
the.right­hand.side.
Installing.the.clamping.lever.on.the.right.can.also.reduce.brake.disc.
L L
squeal.
Centre.the.front.wheel.precisely.in.the.dropouts.of.your.MAGURA.
) .
. s uspension.fork.–.check.for.correct.direction.of.rotation.
Adjust.and.close.the.quick.release.skewer.in.line.with.the.user's.
) .
. i nstructions.
... using the Magura M15 thru axle clamping system
Danger of accident due to faulty installation work.
MAGURA.M15.must.be.combined.exclusively.with.MAGURA.suspension.
Î –
forks.with.dropouts.for.thru.axle.(PM.7").
Insert.the.front.wheel.into.the.dropouts.
) .
sion.fork.–.check.for.correct.direction.of.rotation.
Push.the.MAGURA.M15.axle.from.the.right.through.the.dropout.and.
) .
[ ]
hub.axle. .
D1
Screw.the.MAGURA.M15.axle.clockwise.finger­tight.into.the.left.drop­
) .
out.of.your.suspension.fork.
Tighten.the.MAGURA.M15.axle.with.a.tightening.torque.of.10 n·m
) .
(89 lbf·in).
Insert.emergency.tool. ( 2 ) .into.the.MAGURA.M15.axle.from.the.left.
) .
Familiarize.yourself.with.the.force.required.to.reach.the.required.tight­
L L
ening.torque..This.will.allow.you.to.tighten.your.front.wheel.securely.
without.a.torque.wrench.even.when.you.are.away.from.home.
i
nstallatiOn
.on.your.MAGURA.suspen­
( 1 )
27