Carrera RC CRC X1 Instrucciones De Montaje Y De Servicio página 21

• Look for a suitable environment for flying.
• Slide the battery into the battery bay on the
bottom of the Quadrocopter.
• Connect the battery in the model.
• WARNING! Immediately after switching it
on, place the Quadrocopter on a flat and
level surface. The gyro-system will then
set itself automatically.
• The LEDs on the quadrocopter flash.
• Switch on the controller at the ON/OFF
switch. Be sure to check the Beginner-Ad-
vanced switch (
13b
stick, i.e. the throttle lever, right to the top,
then fully downwards into the zero position.
• Allow the Quadrocopter a few moments un-
til the system is correctly initialised and is
ready for operation. The LED in the Quadro-
copter now lights continuously. The LED on
the controller now lights continuously.
• Repeat the above points as required, if you
wish to fly more Quadrocopters at the same
time.
• Important note! Please perform the au-
to-trimming before each flight without
14
fail!
• Check the control system.
• Make yourself familiar with the control system.
• Trim the Quadrocopter as necessary as
described under
14
hovering it no longer moves from the spot
without a command from the controller.
• The Quadrocopter is now ready to be flown.
• If the Quadrocopter displays no functions,
retry the above binding procedure.
• Fly the model.
• Land the model.
• Disconnect the battery plug connection.
• Always switch off the remote control last.
Flying the 4-channel Quadrocopter
NOTE!
Take care particularly in the first few
flights to move the lever on the control-
ler very gently and not over-hurriedly. As
a rule, only very small movements of the
respective levers are necessary to carry
out the desired control commands!
2b
). Push the left-hand joy-
, so that when
15 16 17
If you notice that the Quadrocopter moves
forwards or to the side without your touching
the respective lever, please adjust the trim of
the Quadrocopter as described in
9 +/- Gas (up / down)
To start or to fly higher, push the gas le-
ver on the left cautiously forwards. To land
or fly lower, push the gas lever on the left
cautiously backwards.
To make the Quadrocopter circle to the left
10
or the right on the spot, move the lever on
the left cautiously to the left or the right.
To fly the Quadrocopter to the left or the
11
right, push the lever on the right cautiously
to the left or the right.
To fly the Quadrocopter forwards or back-
12
wards, push the lever on the right cautious-
ly forwards or backwards.
Looping function
WARNING!
ONLY FOR EXPERIENCED PILOTS!
If you press the "Looping Button", then an
13 a
acoustic signal sounds 5x times. As long as
the acoustic signal sounds, slide the right-
hand joystick up, down, to the right or to the
left. The Quadrocopter then carries out the
loop or roll in the respective direction. Be-
fore you do this, make sure you have ample
room on all sides (about 2.5 m – 8').
Beginner/Advanced switch
WARNING!
100 % IS ONLY FOR EXPERIENCED PILOTS!
13 b 30% = beginner mode
Signal sounds once on switching over.
60% = medium mode
The quadrocopter reacts more sensitively
than in 30 % mode. Signal sounds twice
on switching over.
100% = Advanced Modus -> 3D Modus
The Quadrocopter reacts very sensitive-
21
ENGLISH
14
15 16 17
.