Door Alignment - LG LSXS22423 Manual De Usuario

NOTE: Regardless of hinge lever type, reinstallation
process is the same.
3. Hook tab on switch side of corner under edge of wire
opening in cabinet top. Position cover (2) into place.
Insert and tighten cover screw (1).
Reinstalling the left (freezer) door
(2 )
(1 )
(4)
(5)
(6)
(7)
Type 1
1. Feed the water tubes through the lower hinge pin and
place the door onto the lower hinge pin.
2. Fit top hinge (6) over hinge lever latch (7) and into
place. Rotate lever (5) clockwise to secure hinge.
NOTE: Regardless of hinge lever type, reinstallation
process is the same.
3. Install the grounding screw (4) and connect all the
wire harnesses (3).
4. Hook tab on door switch side of cover (2) under edge
of wire opening in cabinet top. Position cover into
place. Insert and tighten cover screw (1).
5. Reconnect the water tubes by inserting the tubes into
the connectors.
Collet
Tube
Insert Line
Note: When replace the door, the pipe should be
connected to the same color.

DOOR ALIGNMENT

Remove the base grille before adjusting the doors. See
BASE GRILLE INSTALLATION for reference.
Two methods of door alignment are available based
on the amount of adjustment needed and installation
requirements.
Type 1
Adjusting tool: Flat blade screwdriver
If the freezer compartment door is lo wer than the
refrigerator compartment door, level them by inserting a
leg and rotating it clockwise.
Left leveling
Height
leg
difference
REFRIGERATOR INSTALLATION
(3)
(7)
(5)
(6)
Rivet
Type 2
Height
difference
CF C F C F H
If the freezer compartment door is higher than the
refrigerator compartment door, level them by inserting a
leg and rotating it clockwise.
Heigt
difference
Heigt
difference
C F CF C F H
Type 2
Adjusting tools: 5/16" (8 mm) wrench and 3/4"
(19 mm) wrench
Height
difference
Height
difference
C CF F C H F
Using a 3/4" (19 mm) wrench, turn the keeper nut
clockwise to loosen the keeper nut.
Using a 5/16" (8 mm) wrench, turn the adjustment
hinge pin clockwise or counterclockwise to level the
refrigerator and freezer door.
After setting level door, turn the keeper nut
counterclockwise to tighten.
CAUTION:
Do not overtight the door adjustment
screw. The hinge pin can be pulled out. (Adjustable
range of height is a maximum of 1/2" (1.27 cm)).
AFTER LEVELING THE DOOR HEIGHT
10
Rigth leveling leg
Keeper Nut
Wrench
Up
Adjustment
hinge pin
Down