Turning The Lcd Panel Horizontally; Adjusting The Lcd Panel Slide Position; Adjusting The Lcd Panel Angle; Resetting The Microprocessor - Pioneer AVH-Z7250BT Manual De Instrucciones

Setting the automatic open function
To prevent the display from hitting the gearstick of an automatic vehicle when it is in the
P (park) position, or when you do not wish the display to open/close automatically, you
can set the automatic open function to manual mode.
1
Press .
2
Touch then .
The system setting screen appears.
3
Touch [Auto Flap].
4
Touch the item.
[On]
The LCD panel will open or close automatically when the ignition switch is turned on
or off.
[Off]
You have to press OPEN/CLOSE to open/close the LCD panel.

Turning the LCD panel horizontally

When the LCD panel is upright and hinders the operation of the air conditioner, the
panel can be turned horizontally temporarily.
1
Press and hold OPEN/CLOSE to display the flap menu.
2
Touch to flip the LCD panel down to the horizontal position.
NOTES
• To return to the original position, press and hold OPEN/CLOSE.
• The LCD panel returns to the original position automatically, indicated with a beeping sound 10
seconds after operation.

Adjusting the LCD panel slide position

You can adjust the LCD panel slide position so that the panel is set back or forwards.
1
Press and hold OPEN/CLOSE to display the flap menu.
2
Touch (slide to the back) or

Adjusting the LCD panel angle

Important
• If you can hear the LCD panel knocking against your vehicle's console or dashboard, touch
the flap menu to temporarily level the LCD panel.
8
En
(slide to the front) to move the LCD panel.
• When adjusting the LCD panel angle, be sure to adjust from the flap menu. Forcibly adjusting the LCD
panel by hand may damage it.
1
Press and hold OPEN/CLOSE to display the flap menu.
2
Touch (tilt down) or
viewable angle.
NOTE
As the set angle is saved, the LCD panel will automatically be adjusted to the same position the next
time the LCD panel is opened.

Resetting the microprocessor

CAUTION
• Pressing the RESET button resets settings and recorded contents to the factory settings.
– Do not perform this operation when a device is connected to this product.
– Some of the settings and recorded contents will not be reset.
• The microprocessor must be reset under the following conditions:
– Prior to using this product for the first time after installation.
– If this product fails to operate properly.
– If there appears to be problems with the operation of the system.
1
from
Turn the ignition switch OFF.
(tilt up) to adjust the LCD panel to an easily