Recall Function - Beta 1760/OHM Manual Del Usuario Y Operador

To finish the above STORE function, press the EXIT button shortly.
If you need to clear all memory data:
With the power on, hold the EXIT button and switch from OFF to random and then release the
EXIT button; the LCD display will flash thrice and the buzzer signals thrice as well, which means
all memory data was cleared.

2 recall function

Press the STORE button two seconds to enable the RECALL function.
On the left upper corner appears XXXX, which states the currently stored serial number.
On the right upper corner appears XXXX, showing how many storage numbers are currently used.
Press the PEAKHOLD button shortly once to scan data from 0000 to XXXX continuously.
Press again then to scan again.
Use buttons + & — to select the serial number XXXX on the left upper corner and record
data on the right upper corner.
To finish the above RECALL function, press the EXIT button.
83