Transmitting A Midi Bulk Dump; Assigning Midi Controllers - Yamaha ProR3 Manual Del Propietário

Transmitting a MIDI bulk dump

The ProR3 allows you to transmit any type of data as a bulk dump; memory, program memory
(all programs or a specified program), banks, user ER, or system memory.
1. Repeatedly press the UTILITY key until the MIDI Bulk Out page appears.
2. Use the CURSOR keys (√) (®) to select a parameter.
3. Press the INC or DEC key to select the value.
All
U01–U90,
Program
All
A–D,
Bank
All
A–D,
UserER
All
System
4. Press the RECALL/ENTER key to execute the bulk dump.
Before you begin transmission, make sure that the MIDI device to which the ProR3 is connected
is ready to receive a bulk dump.

Assigning MIDI controllers

Here's how to assign MIDI control numbers to the two controllers. The ProR3 can respond to two
controllers, and a separate page is provided to make settings for each controller.
1. Repeatedly press the UTILITY key until one of the controller assign pages appears.
2. Press the INC or DEC key to specify the control number.
The parameter selected in "Setting MIDI control parameters" of page 16 can be controlled in real-
time by receiving the specified control change message.
MIDI Bulk Out
All Press ENTER
All data (Program, Bank, UserER, System)
The data of the specified USER program.
If All is selected, data for all USER programs.
The data of the specified Bank program change table.
If All is selected, data for all Bank data.
The specified User ER data
If All is selected, all User ER data.
System data settings made for utility functions such as Input Mode, etc.
Controller-1 Assign
OFF
Advanced uses (3) – Utility functions –
ProR3 Digital Reverberator
35