Using The Appliance; Nozzle Attachment - Clatronic BS 1279 Instrucciones De Servicio

Telescope Vacuum Pipe
The height-adjustable vacuum pipe enables
individual alignment to your height. Unlock the
coupling by pressing the key in the direction of the
arrow. Slide the vacuum pipe to the desired length.
To lock the device, release the key until you hear
it lock in place.

Using the Appliance

1. Unwind the length of cable you require.
CAUTION:
• Pull out the cable up to the maximum length indicated
with the yellow mark.
• Never pull the cable out up to the red mark as the
cable winding can be damaged.

NOTE:
If the red mark is visible, pull in the cable with the help of
the cable winding button back to the yellow mark.
2. Insert the mains plug into a correctly installed 230 V, 50 Hz
power socket. Turn the device on by the on/off switch by
pressing down the button.
3. Set the "carpet/hard floor" switch, depending on the floor
covering.
4. Set the vacuum power with the vacuum power regulator
(Min to Max).
5. Vacuum at a steady speed. There is no need to exert pres-
sure.

NOTE:
Pay attention to the range that can be covered with the cable
length!
Vacuum power regulator (5)
Low vacuum power: For curtains and delicate fabrics.
Medium vacuum power: For long-pile velour carpets and textile
flooring.
High vacuum power: For sturdy rugs and floors.
Air Slide (13)
Open the air slide on the hose handle in order to
regulate the airflow or to clear any particles sticking
to the nozzle.
Switching off and Winding up the Mains Lead
1. Turn the vacuum cleaner off by the on/off switch and remove
the plug from the socket.
2. Keep the plug in your hand.
3. Press the cable winding button and guide the cable. Hold
the cable to avoid wrapping.
05-BS 1279.indd 25

Nozzle Attachment

Crevice and
jointed nozzle: For vacuuming upholstery, curtains and in
corners and crevices etc.

NOTE: „2-in-1" nozzle:
When this is folded together it can be
used as a groove nozzle. If you would like
to use the brush nozzle, pull the brush
section in the direction of the arrow until it
locks in place.
Floor nozzle: To clean carpets or smooth surfaces.
Smooth floors: Press down the lever with
Carpets:
Releasing
the nozzles: Pull these off while turning slightly.
Maintenance
Dust bag replacement display (2)
Hold the hose up into air. If the dust bag change display lights
up, the bag is full. Please change it.
Changing the dust bag
• Pull the plug out of the socket.
• Open the lid of the dust bag compartment by the handle (9).
• Then remove the dust bag by pulling it upwards.
• Insert a new bag. Please ensure that the bag is located cor-
rectly in the guide mechanism. Press down the fastener with
the bag. The bag must be located completely in the dust bag
compartment. Close the cover so that it snaps into place.
Filter
Your appliance has two filters.
Motor protection filter (inlet filter):
The inlet filter is located in the dust bag compartment. The
filter is located vertically in the rear section of the dust housing.
Remove the filter by pulling upwards.
Cleaning the Filter Element
Clean the engine protection filter after 10 dust bag changes. If
necessary, the filter can also be washed in warm water without
any additives. Place it back into place only once it is completely
dry!
the brush symbol with your
foot. The brush is now vis-
ible.
Press the lever n the oppo- i
site direction. The brushes
are now retracted.
25
17.08.2010 14:21:56 Uhr