Using The Appliance - Clatronic BS 1286 Instrucciones De Servicio

Not shown:
Accessory holder
Start-up
• Put the connection head of the suction hose (4)
into the hose connection (17) until it mechanically
engages. Simultaneously press the buttons on the
connection head to do so. To detach the hose again,
press the buttons again and pull the connection head
out at the same time.
• Insert the vacuum tube into
the handle if required. (Fig. A)
• Then assemble the floor
nozzle and/or the accesso-
ries. (Fig. B)
• Fasten the accessory holder on the suction hose.
Stick the crevice and brush nozzle (18) from above
into the holder. You will therefore always have them
ready to hand.
Telescope Vacuum Pipe (Fig. C)
The height-adjustable vacuum pipe
enables individual alignment to your
height. Unlock the coupling by press-
ing the key in the direction of the arrow.
Slide the vacuum pipe to the desired
length. To lock the device, release the
key until you hear it lock in place.

Using the Appliance

1. Unwind the length of cable you require.
CAUTION:
• Pull out the cable up to the maximum length
indicated with the yellow mark.
• Never pull the cable out up to the red mark as
the cable winding can be damaged.
NOTE:
If the red mark is visible, pull in the cable with the
help of the cable winding button back to the yellow
mark.
2. Insert the mains plug into a correctly installed power
socket. Turn the vacuum cleaner on by pressing the
on/off switch down with your foot.
3. A suction power regulator is integrated in the on/off
switch. Turn the regulator to adjust the suction perfor-
mance.
Smallest point
Biggest point
= Minimum
= Maximum
4. Vacuum at a steady speed. There is no need to exert
pressure.
CAUTION:
Pay attention to the range that can be covered with
the cable length!
Vacuum power regulator
Low vacuum power: For curtains and delicate fabrics.
Medium vacuum For long-pile velour carpets and
power: textile flooring.
High vacuum power: For sturdy rugs and floor.
Air Slide (Fig. D)
Open the air slide on the hose
handle in order to regulate the
airflow or to clear any particles
sticking to the nozzle.
Switching off and Winding up the Mains Lead
1. Turn the vacuum cleaner off by the on/off switch and
remove the plug from the socket.
2. Keep the plug in your hand.
3. Press the cable winding button and guide the cable.
Hold the cable to avoid wrapping.
Nozzle Attachment
Crevice and jointed nozzle:
For vacuuming upholstery, curtains and in corners and
crevices etc.
NOTE: "2 in 1" nozzle:
When this is folded together it can be used as a groove
nozzle. If you would like to use the brush nozzle, pull
the brush section in the direction of the arrow until it
locks in place.
Floor nozzle:
The floor nozzle is fitted with rollers for improved ma-
noeuvrability.
To clean carpets or smooth surfaces
- Smooth Press your foot onto the brush symbol
floors: of the lever (20). The brushes
are now visible.
- Carpet: Use your foot to switch the lever to the
symbol. The brushes are
now retracted.
Parquet brush:
For large areas such as parquet, laminate or tiles etc.
31