CAMPAGNOLO ERGOPOWER POWER-SHIFT Manual De Instrucciones página 16

• Set the control in the smallest
sprocket position by pressing lever
(A - Fig. 16) repeatedly.
Insert the rear derailleur cable (len-
gth 2,000 mm - ø 1.2 mm) into the
bottom of the control (B – Fig. 17).
• Cut the sheath (on the frame side)
so that it reaches the metal sheath
stop on the frame (C - Fig. 18).
• After cutting the casing at the
suitable length, fit a casing end and
insert the casing in the casing retai-
ner clamp (C - Fig. 18) on the frame.
• Ensure that the cable moves flui-
dly in the sheath.
16
A
17
B
18
C
30
• Pass the cable through the RH slot on
the cable guide plate located under-
neath the bottom bracket box (D - Fig.
19); insert the cable through the pawl
present on the chain stay.
• Fit a casing end (some frames require
the use of the special casing end) on
the 330 mm - diameter ø 4.1 mm casing,
pass the cable through the casing and
insert it in the pawl on the right chain
stay (A - Fig. 20).
• Fit a casing end to the other end of
the casing and secure the cable to
the rear derailleur (refer to the rear
derailleur instruction manual for pro-
per attachment of the cable to the
derailleur).
2.2 - FRONT DERAILLEUR CABLE AND CASING
Lift up the hood and push the
end of the 680 mm long, 4.1 mm
diameter housing into the hole
provided (Fig. 21).
Slightly bend the cable (for the
first 5 – 10 mm) (Fig. 21) to faci-
litate insertion of the same into
the sheath.
31
19
� D
20
�
A
21
B
A