Clean The Machine; Lubricate The Blade; Store The Machine; Troubleshooting - GreenWorks 22147T Manual Del Operario

EN
5.1

CLEAN THE MACHINE

Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
5.2

LUBRICATE THE BLADE

To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
• Put the machine on a flat and smooth surface.
• Use a soft cloth to clean the blades and a brush to remove
more dirt.
• Use a light layer of oil to lubricate the blades along the
top edge of the blade.
We recommend to use the non-pollutant type oil.
6

STORE THE MACHINE

Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
7

TROUBLESHOOTING

Problem
The motor shuts
down whilst work-
ing.
WARNING
NOTE
NOTE
Possible cause Solution
Make sure that
The battery pack is you tighlty instal-
not installed tight- led the battery
ly. pack in the ma-
chine.
The battery pack is Charge the battery
out of power. pack.
The machine has Do not use the ma-
damage. chine and speak to
service center.
English
Problem
The machine
smokes during op-
eration.
The motor is on,
blades do not
move.
Too much noise
and/or vibration is
experienced while
working.
8

TECHNICAL DATA

Voltage
No load speed
Blade speed
Blade length
Cutting capacity
Weight (without battery pack)
Measuered sound pressure level
Guaranteed sound power level
Vibration
Uncertainty
9

WARRANTY

(The full warranty terms and conditions can be found on
Greenworks webpage)
The Greenworks warranty is 3 years on the product, and 2
years on batteries (consumer/private usage) from the date of
6
Possible cause Solution
1. Immediately
stop the ma-
chine.
The machine has
2. Remove the
damage.
battery.
3. Speak to serv-
ice center.
Do not use the ma-
The machine has
chine and speak to
damage.
service center.
Remove battery
The blades are then clear block-
blocked. age from the
blades.
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are loos-
3. Inspect for
en.
damage.
4. Check and
tighten loose
parts.
Do not use the ma-
The parts have
chine and speak to
damage.
service center.
40V
3000
(±10%) /min
3000
(±10%) /min
510 mm
18 mm
3 kg
84 dB(A),
K
PA
99 dB(A)
<2.5 m/s
1.5 m/s
=3 dB(A)
2
2