Operating The Pole Hedge Trimmer - GreenWorks HT-180-XR-T Manual Del Propietário

OPERATION INSTRUCTION
ADJUSTING THE TRIMMER HEAD ANGLE
The trimmer head pivots 135° and can be locked into 7 positions within that range.
1. Squeeze the pivot button (1).
2. While squeezing the pivot button, move the head forward or backward.
3. Release the pivot button once the trimmer head is in the desired position.
4. The trimmer head should lock securely in place.

OPERATING THE POLE HEDGE TRIMMER

TIPS FOR OPTIMUM USE
• Start by trimming the top of the hedge. Slightly tilt the tool (up to 15° relative to the line of cut)
so that the blade tips point slightly towards the hedge (FIG.8). This will cause the blades to cut
more effectively. Hold the tool at the desired angle and move it steadily along the line of cut.
The doublesided blade allows you to cut in either direction.
• In order to obtain a very straight cut, stretch a piece of string along the length of the hedge at
the desired height. Use the string as a guideline, cutting just above it.
• In order to obtain flat sides, cut upwards with the growth. Younger stems move outwards when
the blade cuts downwards, causing shallow patches in the hedge. (FIG.9)
• Take care to avoid any foreign objects. Especially avoid hard objects such as metal wire and
railings, as these could damage the blades.
• Regularly oil the blades.
(See Figure 7.)
-30º
0º
1
15
75º
FIG.7