Hint For Improved Use; Switching The Under-Bench Air Conditioner On And Off - Dometic FreshWell 200 Instrucciones De Uso

Operating the under-bench air conditioner
Switching only the remote control to or from stand-by
In stand-by mode, the remote control display shows only the time.
If the remote control is not pointing to the IR receiver (fig. 2
the control panel, you can activate the remote control or switch it to stand-by
independently from the under-bench air conditioner:
➤ Press the
button.
7.3

Hint for improved use

The following hints will optimise the performance of your under-bench air
conditioner:
z Improve the heat insulation of your vehicle by sealing gaps and hanging
reflective blinds or curtains on your windows.
z If the vehicle has been subjected to direct sunlight for a long time: Operate
the under-bench air conditioner in the "Circulating air" (
windows open for a while before switching on the "Cooling" (
ditioning mode.
z Avoid opening doors and windows as far as possible in the "Cooling" (
mode.
z Select an appropriate temperature and blower speed.
z Align the air nozzles sensibly.
z Make sure the air nozzles and intake grille are not covered by cloths,
paper or other objects.
z Clean the air filter periodically.
7.4 Switching the under-bench air conditioner on and
off
I
NOTE
z When it is switched on, it begins to condition the air to the val-
ues that were set most recently.
z You can use the remote control to switch the under-bench air
conditioner to and from stand-by mode. Press the
When you switch on the under-bench air conditioner, the device waits a few
minutes before operating the compressor.
40
Dometic FreshWell 2000
page 2) on
4,
) mode with the
) air con-
button.
)
EN