Recording - Sony SVT-168 Manual De Instrucciones

Recording

This section shows you how to record the signal from
the video camera in the normal or time lapse mode, to
set the security lock and to record repeatedly on the
same cassette.
1
1
Turn on the power of the equipment to be used.
2
Insert the cassette.
3
Set the recording speed by pressing REC/PLAY
SPEED + or –.
Record- Maximum recording Interval Audio
ing time with 120-
speed minute tape
2 Standard 2
mode
Time
12 14
lapse
24 26
mode
48 50
72 74
96 98
120 122
168 170
Note
In time lapse mode, it is possible to record additionally two
hours longer than the displayed recording time.
In the display window
2 3 4
STOP
x
Tape
recording motion
1/60 Possible Continuous
0.12
0.22
0.42 No Intermittent
0.62
0.82
1.02
1.42
Recording speed
4
Press REC z.
Recording starts.
To stop recording
Press STOP x.
If recording does not start and the cassette is
ejected
The tab on the cassette is removed to protect against
accidental recording.
Displaying the real time (in recording or stop
mode only)
Set the REAL TIME/COUNTER switch to REAL
TIME. The real time will be displayed in the display
window. In playback mode, the display shows the tape
counter regardless of the switch position.
Notes
• Whenever you insert a tape and first start recording,
Adaptive Picture Control (APC) automatically improves
recording quality by adjusting the VCR to the condition of
the video heads and tape. To activate this function, set
APC in the GENERAL SET menu to ON (see page 39).
There is about a 6-second delay before the VCR actually
starts recording when REC z is pressed.
• This VCR is provided with a clog detection function. In
time lapse mode, if recording is not made properly, the
recording indicator will flash on the display window and a
warning signal will be output from the WARNING OUT
terminal. In this case, stop recording immediately and
check the VCR.
• If ALARM DATA REC in the ALARM SET menu and/or
TAPE USED COUNT in the GENERAL SET menu is set
to ON, the VCR will rewind the tape and recording will
start from the beginning of the tape. While the VCR is
rewinding the tape, "<ALARM DATA REC>" and/or
"<TAPE USED COUNT>" flashes on the monitor screen.
• While both TAPE USED COUNT and ALARM DATA
list are being recorded, the REC indicator in the display
window goes out momentarily.
19