Error Messages And Troubleshooting - RK Rose+Krieger MultiControl mono Serie Instrucciones De Montaje

7.10 Error messages and troubleshooting

This chapter includes measures in event of malfunctions. If an error occurs that is not listed in this
table, please contact your supplier.
Problem
Drive / controller wit-
hout function
The drives cannot be tra-
versed any more.
The following faults can only occur if a rechargeable battery is used.
Display
Beeping sound
Display
LED
LED
Possible cause
No power supply
Drive / controller defective
Temperature monitoring or system
protection has tripped.
Device fuse has tripped.
Supply line (mains and / or lifting
column / operating button) inter-
rupted.
Fault
The acoustic alarm warns the user
against the complete discharging
of the rechargeable battery when
in rechargeable battery mode.
Meaning
The rechargeable battery is being
charged.
The charging procedure of the
rechargeable battery is completed.
7. Life Phases
Fault solution
Establish mains connection.
Contact the supplier / dealer.
Eliminate overload (change / remove
load).
Leave the system in idle position for
approx. 20 - 30 minutes with the mains
plug removed.
Contact the supplier / dealer.
Check the supply line and, where
applicable, reestablish the connection.
Fault solution
The rechargeable battery must be char-
ged by plugging in the mains plug.
41