JANE Transporter 2 Manual De Instrucciones página 23

1 Prior adjustments
Changing the position of the handle
1a -
The carrying handle has 2 positions (figure 1a), each one of them
has a specific function:
Position 1: Hood folded.
Position 2: Carrying position. Position for fitting and removing
the carrycot from a JANÉ chassis and for carrying, as well as for
use in the vehicle.
To change the position, simultaneously press the buttons on both
sides of the handle and turn it to the required position.
Reclining the backrest
1b -
The backrest of the TRANSPORTER carrycot can be adjusted from the
outside with the adjustment handle. It can be adjusted to infinite posi-
tions. However, it is very important to bear in mind the following points:
AUTO Position: The backrest will always be in the lowest position, with
the baby always lying down during the journey. (1)
STROLLING Position: The backrest can be reclined by up to 20º when
it is installed on your JANÉ pushchair or out of
the car.(2)
Ventilation channels
Your TRANSPORTER safety carrycot has two types of ventilation chan-
nels to improve the breathability of the product and the comfort of
your baby:
Side ventilation channel. It is fitted with a breathable windbreaker
membrane, that acts as a barrier against the wind but allows for ven-
tilation.
Lower ventilation channel. Pressing the button on the lower part of
the head area gives you two extra ventilation channels for the hottest
1c -
seasons.
23