JANE Transporter 2 Manual De Instrucciones página 25

3 Placing the baby in the safety carrycot
3a -
Unfasten the buckle.
3b -
Loosen the harness by pulling the shoulder straps while pressing
the tightening button.
3c -
Place the baby in the safety carrycot making sure that he is lying
down on the base with his back completely flat. Clip the two
upper ends of the clasp together.
3d -
Insert them in the central lock and press until you hear a click.
3e -
Pull the tightening strap that adjusts the whole harness in just
one movement.
4 Using your TRANSPORTER carrycot
on the pushchair
TRANSPORTER can be anchored on any JANÉ chassis that has the PRO-
FIX system.
4a -
To fit the safety seat on a chassis, insert the connections in the
cavity of the chassis and press until you hear a click.
4b -
To release your TRANSPORTER from the chassis, press the button
on the handle and pull the seat upwards.
WARNING
Do not leave the child unattended.
Always remember to carry your baby with the safety harnesses
correctly buckled.
For the correct development of your baby, we recommend you let
him rest in the lying down position (for babies up to 10kg.)
Any alteration or addition to the device without proper authorisation
from JANÉ may seriously alter the safety of the retaining system.
Failure to follow the instructions carefully for the correct use of
the retaining system may be dangerous for the safety of the baby.
This safety device cannot be used without its cover, or be replaced
by another cover that is not the original, as this is an integral part
of the safety features of the system.
Check that the seat has been positioned correctly.
Ensure that the belt has not been caught between the folding
seats or doors.
It is only suitable for cars fitted with three anchoring point au-
tomatic belts, approved according to Regulation ECE-16 or other
equivalent rules.
Do not use with a two anchoring point belt.
Do not use the carrycot on seats fitted with an Air-bag.
25