JANE Transporter 2 Manual De Instrucciones página 24

Choosing where to install the safety seat
Choosing the correct pace to install the safety seat in the car can re-
duce the risk of injury for your baby in the event of an accident.
The safety carrycot should be installed on the rear seats and in a side-
ways position. You can choose from the following positions:
Option 1: completely central, occupying the middle seat plus part of
the two side seats and using the side seat belts.
Option 2: one side seat plus the middle one, using the side and middle
seat belt (must be a 3-point belt) leaving one seat free for another
passenger. Important: the baby's head should be over the middle seat.
24
2 Installing your carrycot
in the car
In the reclining position, TRANSPORTER must be fitted cross-wise on
the back seats. Decide on which seats after reading the section on
"Choosing where to install the safety seat".
2a -
If you have not lowered the backrest to the lying down position,
the incorrect installation safety device will not allow you to insert
the belt into the fastener.
2b -
Undo one of the belt clips: First turn the double lock red lever and
then open the metal catch.
2c -
Insert the abdominal part of the seat belt into the clip and then
close it again. Repeat the two previous steps for the clip on the
other side.
2d -
Lastly, tighten both belts while pressing the carrycot against the
backrest of the vehicle seat.
To remove the TRANSPORTER carrycot from the vehicle, follow
the steps in reverse, in other words, turn the double lock red le-
ver, open the seat belt clip turning the catch and remove the seat
belt.