Start-Up - LIVARNO LUX 109613 Instrucciones De Montaje

Reflector solar led
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

material such as cable clamps or conduit to fasten the cable, to prevent
damage to the insulation.
Connect the plug connector
cell (see Fig. D).

Start-up

Note:
Connect the main station
first time. The solar cell
motion sensor
When selecting the setup location for the solar cell
solar cell, just as the twilight sensor, are not affected by other light
sources, e.g. street lighting.
The switch
on the main unit
5
Position „OFF":
Position „AUTO":
Position „PIR":
from the main unit cable and the solar
4
to the solar cell
1
also works as a twilight sensor, while the
6
only responds to movement.
3
(Fig. A) features the following functions:
1
Sensor
and spotlight
3
the rechargeable batteries are charged by the solar
cell
. Use this setting to charge drained batteries
6
(see „Charging the rechargeable batteries").
The spotlight automatically switches on or off once
the solar cell
6
long life the LEDs will not be fully powered in this set-
ting, but only provide approx. 25 % of their full light
power (eco mode). When fully charged, the
batteries will provide approx. 8 hours of light in this
setting.
The solar cell charges the batteries in sunlight. The
solar cell
automatically switches the spotlight on
6
in twilight or the dark when the motion sensor
detects movement. The light ON time is preset to ap-
prox. 1.5 minutes. If additional movement is detected
before using for the
6
are off. In direct sunlight
2
detects dusk or dawn. To ensure a
be sure the
6
3
GB/MT
47

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido