Maytag EPIC Z MGDZ400TQ1 Manual De Uso Y Cuidado página 25

TROUBLESHOOTING
First try the solutions suggested here and possibly avoid the cost of a service call...
Dryer will not run
• Has a household fuse blown, or circuit breaker tripped?
Replace the fuse or reset fi_e circuit breaker, if the problem continues, call an electrician.
• Was a regular fuse used?
Use a time-delay fuse.
• Is the dryer door firmly closed?
• Was the Power button firmly pressed?
Press and hold for 1 second.
No heat
• Has a household fuse blown, or has a circuit breaker tripped?
[he drum may be turning, but you may not have heat. Replace the fuse or reset the circuit
breaker. If the problem continues, call an electrician.
• Is the valve open on the gas supply line?
Unusual sounds
• Has the dryer had a period of non-use?
If the dryer hasn't been used for a while, there may be a thumping sound during the first
few minutes of operation.
• Is a coin, button, or paper clip caught between the drum and front or rear of the dryer?
Check the front and rear edges of the drum for small objects. Clean out pockets before
laundering.
• Is it a gas dryer?
The gas valve clicking is a normal operating sound.
• Are the four legs installed, and is the dryer level front to back and side to side?
The dryer may vibrate if not properly installed. See "Installation Instructions."
• Is the clothing knotted or balled up? When balled up, the load will bounce, causing the
dryer to vibrate. Separate the load items, and restart the dryer.
Dryer displaying code message
• "PF" (power failure), check the following:
Was the drying cycle interrupted by a power failure?
Press POWER, and then press and hold START to restart the dryer.
• "E" Variable (Et, E2, E3) service codes:
Call for service.
Clothes are not drying satisfactorily, drying times are too long, or load is too hot
• Is the lint screen clogged with lint?
lint screen should be cleaned before each load.
Fire Hazard
Use a heavy metal vent,
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions can result in death
or fire.
• Is the exhaust vent or outside exhaust hood clogged with lint, restricting air movement?
Run the dryer for 5-10 minutes. Hold your hand under the outside exhaust hood to check
air movement. If you do not feel air movement, clean exhaust system of lint or replace
exhaust vent with heavy metal or flexible metal vent. See "installation instructions."
• Are fabric softener sheets blocking the grille?
Use only one fabric softener sheet, and use it only once.
• Is the exhaust vent the correct length?
Check that the exhaust vent is not too long or has too many turns. Long venting will
increase drying times. See "Installation instructions."
• Is the exhaust vent diameter the correct size?
Use 4" (10.2 cm) diameter vent material.