Maytag EPIC Z MGDZ400TQ1 Manual De Uso Y Cuidado página 5

:ili;iiiiiiiiiiiiiiiiiiiiiiiiiiii!iiiiii iiiIi!iiiiIi!iiiiIi!iiiiIi!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiiii!iiiii_iii!i:iii!_!_!_!_!_i!!ii!_i!_!_!_!_!_i!i_ii!_i!ii!!_!_!_!_!!!g!!>:i_!;i_!!!ii:;>_!_i_!;i_!_i!!!!!!!!!_i_!ii!!!_i!!_!iiiii iiiiiii_i ¸ !!_!_!_!_!_!_i!i_ii!_i!_ii!!_!_!_!_!_i!i_ii1!_!_!_!_!!_!Ii_i!ii_i_!!!iii!i:iii!!_i!!ii_iiii!!_!_i!i_ii!_i_!ii!ii!!_!_!!i!!:!ii_iiii_iXi_i_i_i!i!iiiii_i_i_i_i_i_i_i_i_ ¸i ¸
INSTALLATION INSTRUCTIONS
Gather fine required tools and parts before starting installation. Read and follow the
instructions provided with any tools listed here.
• 8" or 10" pipe wrench
• 8" or 10" adjustable wrench (for gas
connections)
• Flat-blade screwdriver
• Adjustable wrench that opens to 1"
(2.54 cm) or hex-head socket wrench
(for adjusting dryer feet)
• V2' nut driver or socket wrench
(recommended)
• level
• Vent clamps
• Knife
• Pipe-joint compound resistant to [.P gas
• Caulking gun and compound (for
installing new exhaust vent)
• Pliers
• Tape measure
Are you placing the dryer on a pedestal? You have the option of purchasing pedestals of
different heights separately for this dryer. You may select a 10" (25.4 cm) pedestal or a
15.5' (5¢9.4 cm) pedestal with a storage drawer. [he pedestal will add to the total height of the
dryer for a total height of approximately 46" (11 6.8 cm) or 51.5' (1 _¢0.8 cm), respectively.
For a garage installation, you will need to place the 10" (25.4 cm) pedestal at least
9' (22.9 cm) above the floor. You will need to place the 15.5' (5¢9.4 cm) pedestal at least
3' (7.6 cm) above the floor.
Parts supplied
Remove parts package from dryer drum. Check that all parts were included.
4 [ewfling legs
NOTE: Do not use leveling legs if installing the dryer on a pedestal.
Parts needed
Check local codes and with gas supplier. Check existing gas supply, electrical supply and
venting. Read "Electrical Requirements," "Gas Supply Requirements" and "Venting
Requirements" before purchasing parts.
• For close-clearance installations between 28.65" (72.77 cm) and 34.15" (86.74 cm), see
"Plan Vent System" section for venting requirements.
(86.74 cm)
Mobile home installations require special parts (listed following) that may be ordered by
calling the dealer from whom you purchased your dryer. For further information, please refer
to the "Assistance or Service" section.
• Mobile Home Installation Kit. Ask for Part Number 346764.
Optional pedestal ( t5.5" 139.4 cm] model shown)
The pedestals are available in several colors.
lb order, call the dealer from whom you purchased your dryer or refer to the "Assistance or
Service" section.
Pedestal Height Color Part Number
10" (25.4 cm) White MHP1000SQO
10" (25.4 cm) Black MHP1000SB0
15.5" (39.4 cm) White MHP1500SQ0
15.5" (39.4 cm) Black MHP1500SB0
15.5" (39.4 cm) Pacific Blue MHP1500SK0
Stack Kit
Are you planning to stack your washer and dryer? 1o do so, you will need to purchase a Stack
Kit. lo order, call the dealer from whom you purchased your dryer or refer to the "Assistance
or Service" section. Ask for Part Number 8212640.
• Metal exhaust system hardware.