Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
To reduce the risk of fire, electric shock, or injury to persons when using the dryer, follow basic precautions,
including the following:
[]
Read all instructions
before using the dryer.
[]
Do not place items exposed to cooking oils in your dryer.
Items contaminated
with cooking oils may contribute
to
a chemical
reaction that could cause a load to catch fire.
[]
Do not dry articles that have been previously cleaned in,
washed in, soaked in, or spotted with gasoline, dry-
cleaning solvents, or other flammable or explosive
substances
as they give off vapors that could ignite or
explode.
[]
Do not allow children to play on or in the dryer. Close
supervision of children is necessary when the dryer is
used near children.
[]
Before the dryer is removed from service or discarded,
remove the door to the drying compartment.
[]
Do not reach into the dryer if the drum is moving.
[]
Do not install or store the dryer where it will be exposed
to the weather.
[]
Do not tamper with controls.
[]
Do not repair or replace any part of the dryer or attempt
any servicing unless specifically recommended
in this
Use and Care Guide or in published user-repair
instructions that you understand and have the skills to
carry out.
[]
Do not use fabric softeners or products to eliminate static
unless recommended
by the manufacturer
of the fabric
softener or product.
[]
Do not use heat to dry articles containing foam rubber or
similarly textured rubber-like
materials.
[] Clean lint screen before or after each load.
[]
Keep area around the exhaust opening and adjacent
surrounding
areas free from the accumulation
of lint, dust,
and dirt.
[] The interior of the dryer and exhaust vent should be
cleaned periodically by qualified service personnel.
[]
See installation instructions for grounding requirements.
SAVE THESE iNSTRUCTiONS
In the State of Massachusetts,
the following installation instructions apply:
[] Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
[] If using a ball valve, it shall be a T-handle type.
[] A flexible gas connector, when used, must not exceed 3 feet.
iMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA
54 or the Canadian Natural Gas and Propane Installation Code, CSA B149.1.
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.
4
Publicidad
Tabla de contenido
