Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
EN
How To Prepare the Machine For Operation
4.
Observe indicator light to ensure the charging process has
started. Flashing light(s) indicates that the batteries are being
charged. Steady on green light indicates the batteries are fully
charged.
NOTE: Make sure you plug into a circuit that is not loaded by other
equipment. Wall breakers may be tripped and no charge will occur.
WARNING:
Never charge a GEL battery with an unsuit-
able battery charger. Carefully follow the
instructions given by the manufacturer of
the batteries and battery charger.
NOTE: To prevent permanent damage to the batteries, avoid their
complete discharge. Never leave the batteries completely dis-
charged, even if the machine is not being used. When recharging
the batteries, keep the recovery tank open. After every 20 recharging
cycles, check the level of the electrolyte and if necessary top off with
distilled water.
How To Adjust Brush Cleaning Path from 24" to 26"
1.
Insure brush head is in up position.
2.
Turn the key switch "OFF" and remove the key.
3.
Open front cover.
4.
Raise plunger pin and rotate brush head. See figure 16.
5.
Insure plunger pin is engaged in brush plate.
6.
Close front cover.
How To Install The Brushes Or Pad Drivers
To install the brushes or pad drivers on the machine,
follow this procedure:
1.
Turn the key switch "ON".
2.
Raise the brush head by pressing and holding the brush
switch until brush head is in its full up position.
3.
Turn the key switch "OFF" and remove the key.
4.
Go to the front of the machine and unlatch front cover, swing
cover open.
5.
Unlatch right and left brush housings and remove them. See
figure 17A.
6.
Put a brush or pad driver under the brush motor plate. See
figure 17B.
7.
("L" Model) Align the lugs on the motor gimbal with the slots
in the brush gimbal.
("S" Model) Align the lugs on the motor with the slots on the
brush gimbal.
8.
("L" Model) Pull the brush up until the gimbal locks.
("S" Model) Pull the brush up and rotate counter direction to
scrub rotation, until lugs lock.
9.
Repeat steps 6, 7, and 8 to install the second brush or pad
driver.
10. Reinstall right and left brush housings and latch front cover.
DANGER:
Operating a machine that is not completely or
fully assembled could result in injury or
property damage. Do not operate this machine
unless it is completely assembled. Inspect the
machine carefully before operation.
Page
-16-
Clarke
®
Operator's Manual (EN) - Encore S2426 / L2426 / S2426 OBC / L2426 OBC
Figure 16
Figure 17A
Figure 17B
Publicidad
Capítulos
Tabla de contenido
