Safety Devices; Safety And Information Signs - Angelo Po 0N0TPG Manual De Uso

Even if the equipment has all its safety devices, if
necessary, during the installation and connection
other safety devices may be supplemented in ac-
cordance with applicable laws.
The illustration shows the position of the
devices.
Gas supply tap: for turning the connection to
A)
the gas supply line on and off .
Safety thermocouple: cuts out the gas sup-
B)
ply if the fl ame goes out.
Important
Make a daily check that the safety devices are
properly installed and in good working order.
The illustration shows the position of the signs
provided.
Nameplate with manufacturer and
A)
appliance data.
General hazard: General hazard: read the
B)
manual carefully before carrying out any
procedure.
General hazard: when washing the appli-
C)
ance do not point pressurised water jets at
internal parts.
General hazard: all relevant regulations
D)
must be complied with. "Install in compli-
ance with the relevant regulations and use in
well ventilated premises only".
General hazard: all relevant regulations
E)
must be complied with. "No liability is ac-
cepted in case of failure to comply with the
installation and commissioning instructions".
Burn hazard: watch out for hot surfaces.
F)
CE marking: this indicates that the equipment
G)
is compliant with all relevant laws applicable to
the product.
3320090_ut_GB_rev.1

SAFETY DEVICES

SAFETY AND INFORMATION SIGNS

- 5 -
B
A
E
D
F
37M3202
C B
GB
G
A
ITALIANO