Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
The nameplate shown here is fi tted directly to
the appliance. It contains references and all es-
sential information for operating safety.
Extra nameplate
A)
a
) Country of use
1
a
) Appliance category
2
a
) Type of gas
3
a
) Gas pressure
4
a
) Type of fume exhaust vent
5
Nameplate
B)
b
) Appliance model
1
b
) Type of customisation
2
b
) Manufacturer identifi cation
3
b
) Serial number
4
b
) Protection class
5
b
) EC conformity mark
6
b
) Reference standard
7
b
) EC certifi cate number
8
b
) Product family type
9
b
) Type of gas
10
GB
For all requirements contact the agents or the
headquarters of Angelo Po which can be found
in the contacts section of the website http://
www.angelopo.com.
3320090_inst_GB_rev.1
IDENTIFICATION OF MANUFACTURER AND APPLIANCE
PROCEDURE FOR REQUESTING SERVICE
b
) Rated power (kW)
11
b
) Gas consumption
12
b
) Testing gas indicator frame
13
b
) Voltage (V)
14
b
) Frequency (Hz)
15
b
) Electricity power consumption (W)
16
b
) Test voltage indicator
17
b
) Date of construction
18
Testing gas plate
C)
c
) Type of gas
1
c
) Gas pressure
2
The installer must select the plate (A)and ap-
ply it alongside the nameplate relating to the
country of use, and must mark the relative ap-
pliance class (Type A = standard fume exhaust
vent).
If the appliance is to be used with the same type
of gas as used by the manufacturer for testing,
the installer has to remove the plate (C) and ap-
ply the indicator
(b13)
for use on the nameplate.
When requesting service, state the data provide
on the nameplate and provide a description of
the fault.
- 4 -
against the data of the gas
ENGLISH
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
