Setting The Work Area - Aventics R412004397 Instrucciones De Servicio

62 AVENTICS | Position Controller | R412004397–BDL–001–AC
Commissioning the position controller
7.2

Setting the work area

Increased valve wear due to continual pulsing in the
end position!
The service life of the valves will be reduced.
O
Make sure that the piston rod does not hit the bottom or
top of the valve.
Independent of the version and size, you have to
set the work area of the position controller before
commissioning.
1. To do this, set the potentiometer as follows before switching
on the operating voltage:
15
14
13
12
Fig. 10: Position controller potentiometer
Potentiometer
Set 0% (14)
Set 100% (13)
P (15)
F (12)
NOTICE
Frame size
-
-
-
Size I
Size II
Size III
13
14
15
12
Scale value
Basic setting
Left stop
Right stop
30
Approx. 1.25
Approx. 0.5
Approx. 0.3