Setting Parameters - Rothenberger ROWELD P 250 B Instrucciones De Uso

(ROWELD P 250/8 B: the total cylinder surface is 6.26 cm²)
(ROWELD P 355/12 B: the total cylinder surface is 6.26 cm²)
(ROWELD P 500/18 B and P 630/24 B: the total cylinder surface is 14.13 cm²)
(ROWELD P 630/24 B Plus the total cylinder surface is 22.38 cm²)
3.5

Setting parameters

To set the parameters with „welder" rights:
 Press the adjusting knob (4) for a long time (about 3 sec.) until P001 blinks in the upper
display (2).
 Use the adjusting knob (4) to select the desired parameter P001 to P009. If this value must
be adjusted or displayed, briefly press the adjusting knob (4). The (default) value blinks in the
lower display (9).
 Use the adjusting knob (4) to set the value, and press the adjusting knob (4) briefly again.
Then the parameter blinks again in the upper display (2).
 To leave the menu, press the release button (10). The values are stored.
How to set parameters with „master" rights:
 Press the adjusting knob (4) for an extended time (about 6 sec.). First the parameter P001
blinks in the upper display (2). Then „CodE", and the line blinks in the first place in the lower
display (9).
 Then use the adjusting knob (4) to enter the code, and briefly press the adjusting knob (4)
(code = 8001 – during first use the code can be changed as desired through parameter P100).
 Use the adjusting knob (4) to select the desired parameter, P101 to P114. If this value must
be adjusted or displayed, briefly press the adjusting knob (4). The (default) value blinks in the
lower display (9).
 Use the adjusting knob (4) to set the value, and press the adjusting knob (4) briefly again.
Then the parameter blinks again in the upper display (2).
 To leave the menu, press the release button (10). The values are stored.
Parameter
name
P001
P002*
P003
P004
P005
P006
P007
P008
P009
P101
P102
P103
P104
P105
P106
P107
P100
* P002 - Power saving function:
0 - none,
1 - when the miller is running the heating element will be switched off,
2 - when the hydraulic motor is running the heating element will be switched off,
3 - when t4 is running the heating element will be switched off.
38
Description
Remaining energy saver time
Power saving function active
Heating plate temperature offset 5
Pmax for cutting
Target pressure
Target temperature
Timer T1 target value
Timer T4 target value
Pstart for cutting
Deviation for repumping
Lifting time after cutting
Set temperature (min)
Set temperature (max)
Button lock (yes/no)
Lifting pressure
Full runtime until buzzer goes on 50
Change code
default Unit
99 min
0
°C
20 bar
1/10 bar
210 °C
45 sec
6 min
10 bar
5 %
10 1/10 sec 0
160 °C
270 °C
5 sed
135 bar
1/10 sec 0
8001
ENGLISH
min max Rights
0 99 Welder
0 3 Welder
-25 25 Welder
10 50 Welder
Welder
P103 P104 Welder
1 1500 Welder
1 99 Welder
0 P004 Welder
1 50 Master
100 Master
0 300 Master
0 300 Master
0 50 Master
10 160 Master
200 Master
Master