Changing The Image Size - Resize Function (Pc Menu Mode Only); Changing The Clamp Pulse Position (Pc Menu Mode Only) - JVC D-ILA DLA-G150CLE Manual De Instrucciones

Changing the Image Size - Resize Function (PC Menu Mode Only)

The picture image projected can be selectable with the
Resize function which is available only in PC menu mode.
You can choose the video image size projected from the
following: (Factory setting is "Aspect".)
"1:1": The image is displayed at the input resolution. The
picture image projected is not enlarged even if its
number of pixels (resolution) is smaller than that of
the projector's D-ILA element (1365 pixels × 1024
pixels).
Resize: 1:1
Panel: The picture image projected is virtually enlarged to
the full size (1365 pixels × 1024 pixels). The
horizontal and vertical enlargement ratio will differ
depending on the original image and the image will
be deformed.
Resize: Panel
Aspect: While maintaining the original aspect ratio, the video
image projected is virtually enlarged until either the
horizontal or vertical side reaches the full size (1365
pixels × 1024 pixels).
Resize: Aspect
Image enlarged to the aspect size.
(Example: aspect ratio is 16:9)
Image not enlarged (original image)
(Example: aspect ratio is 16:9)
Image enlarged to the aspect size.
(Example: aspect ratio is 5:4)
Full size (1365 × 1024)
Image not enlarged
Image enlarged
to the full size
(1365 × 1024)
Image not enlarged
(Original image)
Full size (1365 × 1024)
Full size (1365 × 1024)
Image not enlarged
(original image)
(Example: aspect ratio is 5:4)
1
Press the MENU button.
The main menu appears on the screen.
2
Select "Set up" with the cursor button
5 5 5 5 or ∞ ∞ ∞ ∞ , and press 3 3 3 3 or the ENTER
button.
The "Set up" submenu appears on the screen.
PC submenu
Set up
Tracking
Phase
Position
Resize
Clamp
3
Select "Resize" with the cursor button
5 5 5 5 or ∞ ∞ ∞ ∞ .
4
Choose "1:1", "Panel", or "Aspect"
with the cursor button 2 2 2 2 or 3 3 3 3 .
5
Press the EXIT button to return to the
previous menu or press the MENU
button to exit the menu mode.
Changing the Clamp pulse position
(PC Menu Mode Only)
When the image is too dark or bright, or when the image is
unstable, switching the position may improve the image
quality. Normally, set to "BP".
1
Press the MENU button.
The main menu appears on the screen.
2
Select "Set up" with the cursor button
5 5 5 5 or ∞ ∞ ∞ ∞ , and press 3 3 3 3 or the ENTER
button.
The "Set up" submenu appears on the screen.
3
Select "Clamp" with the cursor button
5 5 5 5 or ∞ ∞ ∞ ∞ .
4
Choose "ST" or "BP" with the cursor
button 2 2 2 2 or 3 3 3 3 .
5
Press the EXIT button to return to the
previous menu or press the MENU
button to exit the menu mode.
ST: Sync Tip BP: Back Porch
Menu Operations
123
12
ENTER
1:1 Panel Aspect
ST BP
53