Adjusting Tracking/Phase - JVC D-ILA DLA-G150CLE Manual De Instrucciones

Adjusting Tracking/Phase

Normally, tracking and phase adjustments are automatically carried out when a video signal is input to the projector for the
first time, or when the QUICK ALIGN. button on the remote control is pressed.
However, you can manually adjust the tracking and phase on the menu.
If a wide stripe appears on the screen, adjust the lateral size of the picture image and the display area (tracking adjustment)
so the stripe disappears.
Also, if text projected on the screen appears flickers or appears dim, adjust phase adjustment so it becomes clear.
1
Press the MENU button.
The main menu appears on the screen.
2
Select "Set up" with the cursor button 5 or ∞ ∞ ∞ ∞ , and press 3 3 3 3 or the ENTER button.
The "Set up 1" (video mode) or "Set up" submenu appears on the screen.
In video mode: Select set up 2 with the cursor ∞ or 5, and press ENTER button.
The "Set up 2" submenu appears on the screen.
Video submenu
Set up 1
Position ENTER
Gamma Down Cinema Up
4:3 16:9
Aspect ratio
Decoder ENTER
Page 2
ENTER
Decoder is only displayed when there is a signal for the AV
IN terminal.
3
Select "Tracking" or "Phase" with the cursor button 5 or ∞ ∞ ∞ ∞ .
4 Adjust the tracking or phase with the cursor 2 2 2 2 or 3 3 3 3 .
Adjust the tracking and phase of the picture image being projected. To adjust the phase, first check for correct tracking
adjustment.
*To adjust multiple items, repeat 3 and 4.
Adjustment item
Tracking
Phase
5
Press the EXIT button to return to the previous menu or press the MENU button to
exit the menu mode.
Note
• A dim image could be caused by insufficient adjustment of brightness and contrast. Before adjusting phase, make sure that
brightness and contrast are correctly adjusted. To adjust them, refer to "Adjusting Picture Quality" on page 49.
Set up 2
Tracking 123
Phase 12
Screen 4:3 16:9
HDTV 1030i 1035i
Page 1
ENTER
Button
The picture image shrinks laterally (right-to-left) or extends laterally (left-to-
2 or 3
right). (–128 ↔ +127)
2 or 3 Set to a position where text appears clear. (0 ↔ 31)
PC submenu
Set up
Tracking
Phase
Position
Resize
Clamp
Adjustment content
Menu Operations
123
12
ENTER
1:1 Panel Aspect
ST BP
47