Zanussi ZOB22601 Manual De Instrucciones página 12

Ocultar thumbs Ver también para ZOB22601:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or deacti-
vate the circuit breaker.
Put a cloth on the bottom of the oven to
prevent damage to the oven light and
glass cover.
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the
lamp.
1. Turn the glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with an appli-
cable 300 °C heat-resistant oven light
bulb.
Use the same oven lamp type.
4. Install the glass cover.
Cleaning the oven door
The oven door has two glass panels. You can
remove the oven door and the internal glass
panel to clean it.
The oven door can close if you try to re-
move the internal glass panel before you
remove the oven door.
Caution! Do not use the appliance
without the glass panels.
1
Open the door
fully and hold the two
door hinges.
12
2
Lift and turn the
levers on the two
hinges.
3
Close the oven
door to the first open-
ing position (halfway).
Then pull forward and
remove the door from
its seat.
5
Release the lock-
ing system to remove
the internal glass
panel.
2
1
7
Carefully lift (step
1) and remove (step
2) the glass panel.
Clean the glass panel with water and soap. Dry
the glass panel carefully.
Installing the door and the glass panel
When the cleaning is completed, install the
glass panel and the oven door. Do the above
steps in the opposite sequence.
The screen-printing zone must face the inner
side of the door. Make sure that after the instal-
4
Put the door on a
soft cloth on a stable
surface.
90°
6
Turn the two fas-
teners by 90° and re-
move them from their
seats.
www.zanussi.com

Publicidad

Tabla de contenido
loading

Tabla de contenido