ECOVACS DEEBOT U2 Serie Manual De Instrucciones página 27

No. Scenario
DEEBOT cannot return
3
to the Docking Station.
DEEBOT misses
cleaning spots to be
4 cleaned, or repeats
cleaning the area
cleaned.
DEEBOT gets stuck
5 while working and
stops.
DEEBOT is making
6 too much noise when
cleaning.
Possible Cause
The Docking Station is not correctly placed.
The Docking Station is not correctly connected.
The Docking Station is manually moved during the
cleaning.
DEEBOT did not start cleaning from the Docking
Station.
The cleaning cycle is interfered by small objects or
barriers on the floor.
DEEBOT is working on slippery polished floors.
DEEBOT is unable to reach certain areas blocked
by furniture or barriers.
DEEBOT gets stuck while working and stops.
DEEBOT might be stuck under furniture with an
entrance of similar height.
DEEBOT is tangled or blocked with debris.
Solution
Refer to Section 3.2 correctly place the Docking
Station.
Make sure the Docking Station is correctly connected.
It is suggested not to move the Docking Station during
the cleaning.
Make sure DEEBOT starts cleaning from the Docking
Station.
Remove power cords and small objects from the floor
to ensure cleaning efficiency. DEEBOT will automatically
clean the area missed, please avoid moving DEEBOT
manually or block the path during the cleaning cycle.
Make sure the floor wax is dried before DEEBOT starts
cleaning.
Tidy up the area to be cleaned by putting furniture and
small objects in their proper place.
DEEBOT will try various ways to free itself. If it is
unsuccessful, manually remove the obstacles and
restart.
Please set a physical barrier.
Clean DEEBOT as described in section Maintenance
and restart. If the trouble persists, please contact
Customer Care.
EN
27