Cleaning And Caring For The Camera; Guarantee - Waeco PerfectView CAM50 Instrucciones De Montaje

_CAM50.book Seite 34 Montag, 7. Mai 2012 3:12 15

Cleaning and caring for the camera

Aligning the camera
NOTE
I
If necessary before aligning the camera connect the camera to a
monitor and to a power supply (see connecting diagram, fig. i,
page 6
➤ Use the monitor image to align the camera:
The monitor image should show the bottom edge of the rear or the
bumper of your vehicle (A). The middle of the bumper should be in the
middle of the screen. (fig. j, page 6).
➤ Check the function of the camera after you have connected it to a monitor.
Fastening the camera
➤ Thighten the two screws in the slots of the camera bracket.
➤ Mount the side covers with the two screws M3 x 8 mm in the middle drill
holes (fig. k, page 7).
9 Cleaning and caring for the camera
NOTICE! Risk of damage!
A
Do not use sharp or hard objects to clean the device as these may
damage the device.
➤ Clean the camera with a soft, damp cloth from time to time.
10

Guarantee

The statutory warranty period applies. If the product is defective, please
contact the manufacturer's branch in your country (see the back of the
instruction manual for the addresses) or your retailer.
For repair and guarantee processing, please send the following items:
 Defect components
 A copy of the receipt with purchasing date
 A reason for the claim or description of the fault
34
PerfectView CAM50
EN