Maintaining And Cleaning Magicspeed - Waeco MS-BE6 Instrucciones De Montaje Y Uso

Maintaining and cleaning MagicSpeed

Using the last saved speed
Press the RES/DES button to recall the last saved speed when:
You have switched on the speed regulator using the ON/OFF button
You do not press the brake or clutch pedal
You do not switch off the ignition in the meantime
Your vehicle is travelling at over 35 km/h
➤ Press the RES button and let go again immediately to recall the last saved
speed.
Accelerating and decelerating
If the speed regulator is activated, you have the option of fine tuning it. By
doing this you can adapt the speed of the car precisely to suit traffic
conditions or speed limits.
➤ Touch the SET/ACC button to increase the speed by 1 km/h.
➤ Touch the RES/DES button to lower the speed by 1 km/h.
If, for example, you want to increase the speed by around 3 km/h, touch the
SET/ACC button three times.
Note
I
When you press the appropriate button for longer, the speed will
continue to be altered until you let the button go again.
Note
I
If you want to decrease the set speed sharply, do not use the
RES/DES button.
Use the ON/OFF button, the brake or the clutch and then press the
SET/ACC button to set the speed you want.
11 Maintaining and cleaning MagicSpeed
Caution
a
Do not use sharp or hard objects to clean the device as these may
damage the device.
➤ Occasionally clean the control lever with a damp cloth.
36
MagicSpeed Accessory