Lenco DAR-050 Manual Del Usuario página 6

3. Turn on the unit by pressing On/Standby button (5). If the LCD display (1) is on with
backlighting, it means the power supply is normal. Now the system is ready to play the
music.
Setting the clock
1. Set unit in standby mode.
2. Press and hold the Menu/Mem/clk-adj button (16), display will show 24hour, press Skip
down (12) or Skip up
Mem/clk-adj button (16) to confirm, the hour digit will flash on LCD display (1), Press the
Skip down (12) or Skip up
Mem/clk-adj button (16) to store the hour then minute digit will flash.
3. Press the Skip down
4. Press Menu/Mem/Menu/clk-adj button (16) to store the correct hour.
 The pre-set time will be re-set completely if dis-connecting the main power supply. You
are recommended to switch the system into standby mode for convenience usage.
 The clock will synchronous to RDS/DAB clock once receive the RDS/DAB signal if clock did
not setting in advance.
Listening to radio
Operation
Manual tuning
1. Turn on the unit by On/standby button (5) & then press the Function button (7) until it reach
the FM mode.
2. Press the Skip down
3. Adjust volume up/down button (14/15) for the desired volume level.
Auto tuning
1. Set the unit to FM mode.
2. Press the auto scan button (3) once, unit will start to scan at tuning up direct until radio
station received. Press tuning down button (12) once and then press the auto scan button (3),
the unit will scan to tuning down direction. If the radio data system (RDS) broadcasting signal
received, the unit will set the actual time automatically.
3. Adjust volume knob (14/15) for the desired volume level
FM scan setting
After auto tuning if many unwanted weakness radio station received, you can select strong
station only to filter the weakness signal station.
1. In FM mode, press Menu/Mem/clk-adj button (16) to enter the Me u , then press Skip
down (12) or Skip up
2. Press Stop/Enter button (4) to enter the S a setti g , then press Skip down
(13) button to select St o g station onl . Then press Stop/E te
Skip up
to confirm the setting.
3. Perform the auto tuning operation again as above.
FM & FM-stereo reception
 The unit will default the FM mode at Mono. Thus, if FM stereo signal received, set the FM
mode to Stereo by press Menu button (16), then press Skip down
(13) button to select Audio setting, press Enter button (4) and press Skip down
(13) button to select 12 or 24 hrs format, then press Menu/
(13) button to set the correct hour. Press the Menu/
(12) or Skip up (13) button to set the correct minutes.
(12) or Skip up (13) button to tune your desired station.
(13) button to select S a setti g .
6
(12) or
button (4)
(12) or Skip up
(12) or