Timed Delivery; Regulation Conservation Temperature - Taylor C004 Manual De Uso Y Manutención

- Avoid pouring the liquid cream on the pump, during tank filling
- Make sure that sugar is well dissolved in cream to avoid that lumps obstruct the suction
silicone hose
- In any case, the addition of quantities of sugar superior to 8%-10% of the liquid cream
is not recommended because it can limit the increase in volume.
- Never add solids, such as pieces of hazelnut, chocolate and so on, which could
obstruct the pump and damage the equipment
- Avoid to use the pump dry
- Avoid to use the pump with water only
- During operation, always keep the tank cover closed, to avoid the penetration of dust
and impurities into the product
- Before starting dispensing whipped cream, check that the temperature displayed by the
thermometer on the control panel ranges between +1°C(33,8°F) and +5°C(41°F).
Warmer temperatures do not allow cream whipping and hygienic preservation .
-

2.3 Timed delivery

This function is useful in case it is necessary to perform frequent cream deliveries at
constant times. The machine is supplied with delivery time set to zero. To insert a value,
proceed as follows:
1. Press pushbutton "SET", the value "0.0" appears on the display, at the same time press
pushbutton "ON-OFF" to set the new time value. By pulse pressing it, the value on the
display increases 0,2 seconds each time, up to a maximum of 6 seconds, then it return
to zero and the cycle starts again. Keep the pushbutton "ON-OFF" pressed and the
value on the display quickly passes by.
2. Release the pushbutton and the delivery time value is confirmed. The display shows the
cream temperature.
3. Press the delivery pushbutton and the pump starts up until the time, previously set up, is
expired.
4. To reset the time value, or to change it, follow the above-mentioned instructions.

2.4 Regulation conservation temperature

This function is useful in case it is necessary to regulate the temperature of the thermostat
into the product tank. To insert a new temperature value, proceed as follows:
1. Verify that the machine is connected to the electrical net (right led on button ON/OFF
is lighted up) and the machine is OFF (left led on button ON/OFF is off).
7 - ENGLISH