3B Elettronica 8110-AIR5 Manual Del Usuario página 47

USALS MOTOR SETTING:
Select the DISEQC type as USALS MOTOR in order to use the Diseqc Motors with Usals commands. Go ver to the USAL
SETTINGS menu by holding the EDIT button pressed for 2-3 seconds. Enter the coordinates of the region, where you
will perform the satellite setting and mark the OK box and the SATELLITE DISH will AUTOMATICALLY go to the position
of the satellite, when you then go to the GO box and press on ENTER.
UNICABLE I&II SETTINGS MENU:
You can use this menu for the UNICABLE Multiswitch or Unicable SCR LNB types and conduct the tests after having
performed these settings. First, select the DISEQC type as UNICABLE and go to the PORT section and keep the EDIT
button pressed for 2-3 seconds.
You can adjust on this screen the output IF frequencies according to the Unicable Multiswitch or Unicable SCR LNB
type you will test. Then you can test the signals from the SATELLITE SETTINGS menu.
DISEQC 1.2 MOTOR SETTING MENU:
Please keep your charging device available at this scan type.
Rev.0 0.2019 Tel.039616417
First select in the DISEQC TYPE section the option
Diseqc 1.2 Motor and go to the SATELLITE SETTINGS
menu signal levels by pressing on the ENTER
button.Here you can view the signal levels and at the
same time manually rotate with the RIGHT/LEFT
buttons your Diseqc 1.2 Motor in EAST/WEST
directions. Your battery could be discharged faster
than normal since the DISEQC MOTOR will consume
more poser in this menu.
info@3belettronica.com
47
www.3belettronica.com