3B Elettronica 8110-AIR5 Manual Del Usuario página 62

Go to the measurement screen by pressing on the OK button after you have entered the parameters of the frequency
you want to measure.The orange, thick bar on the right of this screen indicates the signal level visually. The signal level
is indicated in figures below the orange bar. You can see from the green area whether the Orange Level Performance
Bar is within the Max Min values you will select in the settings menu. And on the left side of the screen, you can see
the frequency parameters and the signal values like MODULATION, BER, MER. A FAILURE indication will appear in the
small box in the right bottom when the signal values are insufficient and an OK indication when the signal values are
appropriate. The Channel names will be indicated in the orange bar, when the signal levels are appropriate. You can
see the names of the channels in the frequency you have measured by pressing on the LIST button.
Note: You can jump fast to the other menus related to the frequency you have measured with the SPECTRUM,
CONSTELLATION and SEARCH boxes at the very bottom. Detailed information will be provided in the following pages
with regards to the Spectrum Analysis and Constellation features.
SEARCHING A CHANNEL ON THE FREQUENCY AND RECORDING INTO THE CHANNEL LIST:
Go down to the "SEARCH" box in the right bottom section on a frequency you are sure that the signal levels are
appropriate and press on the OK button. You can perform a scan on the CHANNEL SEARCH screen by selecting the
options NON-CODED and ENCODED and both together. The channels you scanned will be found and then the
information screen will appear and you will be asked whether you want the channels to be recorded or not.
ANALOGUE TERRESTRIAL TV MEASUREMENT:
Select ANALOGUE in the SYSTEM box in the TERRESTRIAL TV LEVEL MEASUREMENT menu. Use the RIGHT/LEFT
buttons in order to select the CHANNEL and FREQUENCY you want to measure. You can enter the Video Frequency
and Sound Frequency information for the ANALOGUE TERRESTRIAL TV measurement with the EDIT button by moving
on the boxes. There may be amplifiers at terrestrial TV antennas, you might need to select a supply voltage of 5V, 12V,
20V in this case.
Rev.0 0.2019 Tel.039616417 info@3belettronica.com www.3belettronica.com
62