3B Elettronica 8110-AIR5 Manual Del Usuario página 70

AUTO RANGE: Automatically determines the measuring range according to the highest and lowest signal level on the
Spectrum screen.
FILL / LINE: You can see the levels in the Spectrum screen as full or in line.
CAPTURE FUNCTIONS: You can save your measurement with the SAVE CAPTURE feature at the time of measuring the
Spectrum, and then use the LOAD CAPTURE function to recall and use it as a reference.
SAVE TO USB: You can save the measured values in the Spectrum display as a * .CSV table on your USB display.
DCS1800 SPECTRUM 1800mHz Band :
To measure the 1800mHz band, select DCS1800 SPECTRUM and press OK. Make sure the meter is connected to a
suitable antenna on the 1800mHz band.
In the above ranges of the DCS1800 Spectrum display, you can see the Downlink signals of the GSM operators. Move
the red marker with the right and left buttons to measure the signal levels. You can complete the measurement after
capturing the cleanest and highest signal level in the entire band of the spectrum measurement.
Rev.0 0.2019
EDIT BUTTON: SPECTRUM ANALYSIS screen, you can manually change your measured
values by pressing EDIT.
IF FREQ: You can see the frequency on which the marker is on.
SPAN: You can select the frequency range you want on the screen.
REF .: You can select the highest measuring point.
RANGE: You can select the signal level range you want to measure.
Tel.039616417 info@3belettronica.com
70
www.3belettronica.com