Clatronic KEB 2656 DS Instrucciones De Servicio página 54

5....-05-KEB 2656 DS Neu
1. Make sure that the machine is switched off.
GB
2. Pull out the plug.
3. Place a pitcher of cold water under the steam nozzle and insert the steam
nozzle in the pitcher. Turn the steam head counter-clockwise until the water
container is empty.
4. Turn the steam control button back again.
5. Now you can remove the water container seal and the filter holder.
If there is still water in the water container, remove the glass pot and pour out the
remaining water.
1. Insert the plug in a duly installed protective contact socket. The espresso switch
must be in off position.
2. Place the metal filter (g) in the filter holder (f). Fill the filter up to the desired level
with ground espresso coffee. Do not press too much. Remove any coffee pow-
der on the edge of the filter holder.
3. Place the filter in the machine. Lift the filter holder into the brewing head and
turn it as far as possible to the right until it is firmly in place.
4. Screw in the water container seal (a) counter-clockwise.
5. Fill the fresh, cold water up to the desired mark in the water container with the
aid of the glass pot.
Attention: never fill the water container while the appliance is working. The appli-
ance must be off.
6. Turn the water container seal (a) clockwise.
7. Position the pot lid on the pot (h) so that the opening is directed towards the
pouring mouth of the pot and fit these under the filter holder.
8. If you wish to fill the espresso directly in the cups, fit the cup adapter (j). Place a
cup directly under each of the two openings.
9. Just press the "espresso/cappuccino" key to switch on the appliance. The on/off
display lights up. Turn the espresso strength selector to the desired level.
Note: Please do not turn the espresso strength selector switch too far in the
direction of "Strong" as this prevents the water running into the filter holder.
10. After about 2 minutes the water reaches the right temperature. Now the water
pours through the coffee powder and the espresso flows into the pot or into the
cups.
11. Once the brewing is over, switch the appliance off by pressing the
"espresso/cappuccino" key. The operating LED switches off.
12. Before removing the filter holder for cleaning, make sure that there is no longer
any pressure in the water container (see the section Warning – Pressure).
Warning – Hot Surface:
The filter holder becomes very hot during operation. In order to remove the filter
holder, turn it to the left until the holder comes out of the appliance.
54
08.09.2003 9:30 Uhr
Preparing an Espresso
Seite 54