Connecting A Usb Device - Kenwood DMX9720XDS Guia De Inicio Rapido

HDMI input
7
Use HDMI cable KCA-HD100 (optional
accessory).
When you connect the cable to HDMI terminal,
remove the fixture. After connecting the cable,
put the fixture again.
8 Digital Radio antenna CX-DAB1 (Optional
accessory)
!
Use of a CX-DAB1(optional accessory) as a
Digital Radio antenna is recommended.
When using a commercially available Digital
Radio antenna, the diameter of the SMB
connector must be Φ6.5 mm or less.
Dashboard camera interface
9
Connect a Dashboard Camera DRV-N520
(optional accessory). (P.23)
10 AV Audio input (ø3.5 mini jack)
11
Accessory 6: GPS Antenna
Use the supplied GPS antenna. Using the GPS
antenna other than the supplied one may
cause a drop in positioning accuracy.
3rd view camera input (Yellow). See To set up
12
the camera assignment settings (P.23).
Rear view camera input (Yellow) *
13
Front view camera/Dashboard camera
14
See To set up the camera
input (Yellow).* 2
assignment settings (P.23).
15 Video output (Yellow)
16 Video input (Yellow)
*1 Connect an HD camera to Rear view camera
input terminal to use HD video.
*2 Connect an HD camera to Front view camera/
Dashboard camera input terminal to use HD
video.
Fixture
HDMI connector
Φ 6.5 mm (maximum)
1
Ñ
Securing the USB extension cable
Secure the USB extension cable with insulating
tape or the like so that its connectors are not
disconnected.
Ñ

Connecting a USB device

Accessory 2 (1 m)
USB terminal
USB maximum power supply current :
[1]
DC 5 V = 1.5 A
[2] Sold separately
See Securing the USB extension cable
[3]
(P.21).
Connection/Installation
[3]
USB device
[2]
[1]
English
21