Descargar Imprimir esta página

Siemens Euroset 3010 Instrucciones De Manejo página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

Call Waiting:
If during a conversation you hear the
warning tone of a waiting call, you can
answer it by pressing the Call Waiting key
. The first call will be retained.
When you wish to pass from one call to
another, press the Call Waiting key
again. The procedure can be repeated as
many times as you wish. To finish the
communication in progress and continue
with the other, press the Call Release key
. To finish the last communication, just
hung up.
Consultation:
When, during a conversation, you wish to
make a consultation, press the FLASH key
to get the dial tone again. Dial the
desired number to set up the consultation
communication.
Once the consultation is made, press the
Call Waiting key
to change between the
calls or the Call Release key
the
communication
in
progress
continue with the other one.
Conference:
The conference service allows the setting
up of communication among three people.
Firstly set up two communications by using
the
procedures
of
Call
Waiting
Consultation described earlier. Then press
the Conference key
to establish
simultaneous communication among the
three people.
Mailbox:
The Mailbox service allows messages to be
stored so that the user can hear them later.
This service has an access code that can
be programmed in the Mailbox key
following the same steps of number storage
procedure in the one-touch memories (see
the item Storing phone number in
memories on page 4).
Operator code
If necessary, this telephone is able to be
programmed with the operator code of your
preference. This operator code can be
programmed in the Operator key
(position 7 on page 1), following the same
steps of number storage procedure in the
one-touch memories (see the item Storing
phone number in memories on page 4).
Note:
The operator code is valid just for the
countries where this service is available.
to finish
and
or
,
9

Publicidad

loading