While the refrigerating unit is running, beads of condensation
or hoarfrost form at the back of the refrigerator. This is
normal. It is not necessary to wipe off the condensation or
frost. The rear panel defrosts automatically. The condensation
runs into the condensation channel and is conveyed to the
refrigerating unit from where it evaporates.
Note: Keep the condensation channel and drainage hole
clean, so that the condensation can run out.
DOOR CONVERSION
If you need to hinge your door on the opposite side it is recommended that you call your local authorised
service agent to make this conversion or ask a technician.
Before you reverse the door, you should ensure the appliance is unplugged and empty. It is
recommended to use a crosshead screwdriver and a spanner (both not supplied).
1. Remove the 2 screws on the back of the top
cover.
3. Remove the three screws and then remove the
top hinge that holds the door in place. Lift the
door and place it on a padded surface to prevent
it from being scratched.
Remove the plug to the drainage hole.
2. Lift the top cover away from the fridge.
4. Remove the bottom screw, hinge bracket and
adjustable foot from the bottom of the
appliance.
13
GB