To Attach And Remove The Cabin - Husqvarna P 520D Manual De Usuario

6. Pull the spring (A) and remove the lifting eyes (B).
7. Start the engine.
8. Put the lift lever to the position (B) to lower the lift
arms.
B
WARNING: Do not put the lift lever to
the mow position (A). The hydraulic force
can cause serious injury.
9. Stop the engine.
10. Remove the 2 screws and remove the bottom plate.
11. Lift off the rubber casing from the shaft joint.
12. Pull back the coupling of the drive shaft and remove
the drive shaft from the shaft journal.
13. Remove the lock chains.
740 - 004 -
B
A
14. Remove the pins (A) and the bolts (B) from the lift
arms.
A

To attach and remove the cabin

1. Remove the door of the cabin. Refer to
and remove the door on page 16 .
2. Remove the emergency door of the cabin Refer to
To attach and remove the emergency door on page
16 .
3. Remove the rubber straps and open the engine
cover.
4. Disconnect the battery.
5. Remove the 3 screws and remove the side cover.
6. Remove the 4 screws and remove the protective
cover of the fuse box.
7. Disconnect the cable.
8. Put the rubber grommet in the empty slot.
B
A
B
To attach
15