To Replace The Engine Oil - Husqvarna TS 354XD Manual De Usuario

To remove the lower cover
1. Lift the engine cover.
2. Remove the fastener (A) from the lower cover
(B).
B
A
3. Carefully lift the lower cover (B) to release the
cover tabs (C) for the slots that taper (D).
CAUTION:
lift the lower cover, there is a risk of
damage to the lower cover tabs (C).
4. Remove the lower cover.
To install the lower cover
1. Install the lower cover (B).
2. Carefully push the lower cover (B) to attach it to
the cover tabs (C) in the slots that taper (D).
B
A
CAUTION:
attach the lower cover, there is a risk
of damage to the lower cover tabs
(C).
3. Install the fastener (A) to the lower cover (B).
4. Lower the engine cover.

To replace the engine oil

If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the
engine oil faster to drain.
Before the engine oil is replaced, find the correct oil
temperature range.
Note:
All oil must follow the recommended API
service class SG-SL.
30
D
C
Be careful when you
D
C
Be careful when you
CAUTION:
goes into the engine when you replace
the engine oil. Dirt can cause damage to
the engine.
WARNING:
hot directly after the engine stops. Let
the engine become cool before you drain
the engine oil. If you spill engine oil on
your skin, clean with soap and water.
1. Park the product on a level surface.
2. Remove the lower cover. Refer to
lower cover on page 30 .
3. Remove the dipstick.
4. Install the oil drain tube (A) on the engine oil
drain valve (B).
5. Put a container below the engine to catch the
engine oil.
6. Turn the oil drain valve counterclockwise to open
the oil drain valve. Use a 10 mm wrench.
7. When all engine oil is drained, turn the oil drain
valve clockwise to close it. Use a 10 mm wrench.
8. Use the 10 mm wrench to carefully torque the oil
drain valve closed. Do not tighten too tightly.
CAUTION:
much torque when you tighten the oil
drain valve.
9. Remove the oil drain tube from the oil drain
valve.
10. Fill the engine with new engine oil through the
dipstick tube. Fill slowly. Do not fill the engine
with too much engine oil. For the approximate
Technical data on page 38 .
capacity, refer to
11. Do a check of the engine oil level. Refer to
a check of the engine oil level on page 29 .
12. Install the lower cover. Refer to
lower cover on page 30 .
Make sure that no dirt
The engine oil is very
To remove the
A
B
Do not apply too
To do
To install the
1940 - 006 - 13.09.2022