Unold 48860 Instrucciones De Uso página 30

Valve closed
completely assembled and switched on before you add the desired ingredients.
Never put the required ingredients into the cooling container beforehand! The
ingredients can freeze onto the edge of the container and the desired soft
30
marking on the underside of the appliance. You will hear a
click when the discharged valve is placed correctly.
4. Fit the upper part of the housing onto the lower part
of the housing. Note that the feet on the upper part of the
housing must be slide precisely into the arms of the lower
part of the housing.
5. Then the cooling container with ring must be inserted
into the upper part of the housing. There is a small tab
on the ring that precisely fits into the corresponding aper-
ture on the upper part of the housing. This is the only way
to precisely insert the cooling container and placing the
appliance in operation.
6. Now place the motor on the lid. The motor can only be
placed on the lid in one position. Note that the two locking
tabs on the motor must lock into the corresponding
apertures on the lid.
7. Fit the mixer into the aperture on the underside
of the motor. Ensure that the mixer locks in place
and is firmly seated, it may be necessary to exert
some pressure here.
8. Place the lid with motor and mixer in the upper part of
the housing/cooling container. The motor must by on the rear
part of the housing (see Fig.), and the three locking tabs of
the lid must be turned into the apertures on the ring. The lid
is correctly locked when it can no longer be lifted off of the
appliance.
Valve open
Copyright UNOLD AG | www.unold.de
9. Caution: Before each use,
ensure that the discharge valve is
sealed. The lever must be pressed
upward to the "Close" position. If
you press the lever downward, the
valve is open and the ingredients
flow out of the appliance.
10. Caution: The appliance must be