Unold 48860 Instrucciones De Uso página 33

15. Thoroughly clean all parts with warm water and a mild washing-up liquid,
then dry all parts thoroughly.
16. Put the component parts back together again in the reverse sequence:
17. Slide the middle axle into the mixer to the stop.
18. Firmly screw in the mixer blade (turn counter-clockwise).
19. Slide the lower axle through the middle axle, guide the upper end of the axle
into the holder, and fix it in place with the locking ring.
Cooling container with ring
20. Caution: If condensation forms between the cooling container and the upper
part of the housing, removal of the cooling container is more difficult. Do
not use force to pull the cooling container out of the upper part of the hous-
ing; in this case wait until all parts have warmed up to room temperature.
21. To prevent injury or freezing, allow the cooling container to warm up to room
temperature, before you clean it.
22. Turn the ring clockwise and pull it downward and off of the cooling con-
tainer.
23. Wipe off the inside of the cooling container with a damp cloth and then dry
it thoroughly.
24. Likewise, wipe off the locking ring with a damp cloth and then dry it care-
fully.
Discharge valve
25. Take the upper part of the housing off of the lower part of the housing.
26. Carefully turn the discharge valve clockwise and take it off.
27. Thoroughly clean all parts with warm water and a mild washing-up liquid,
then dry all parts thoroughly.
28. To re-insert the discharge valve, place in on the underside of the upper part
of the housing and turn it slightly counter-clockwise until it locks in place.
Housing parts
29. Thoroughly clean all parts with warm water and a mild washing-up liquid,
then dry all parts thoroughly.
Storage
30. Store all parts in a dry, dust-free and clean location. Tip: Keep the appliance
packaging and store the soft ice cream machine in this box when the soft ice
cream machine is not in use.
Copyright UNOLD AG | www.unold.de
33