TRACTION
TRACTION
TRACTION
TRACTION
These machines are equipped with electronically commanded traction, and continuous
speed variation.
To move the machine, rotate the key into position ON, wait for three seconds and then
push forwards (forward movement) or backwards (rear movement) the lever placed on
the handle bar.
For safety reasons, in reverse motion, the speed movement is reduced.
ATTENTION!
ATTENTION!
ATTENTION!
ATTENTION! When carrying out even short backward movements,
make sure that the squeegee is lifted .
BRAKES
BRAKES
BRAKES
BRAKES
The machine is equipped with two braking systems: a working brake controlled by the
lever on the rear left side (2) and a parking and emergency brake controlled by the lever
placed on the rear right side (1).
Lower the levers to operate the brakes.
The lever of the emergency brake is equipped with a blocking device. To release this
brake, press the trigger placed on the lever (1) itself.
DEVICE TOO FULL
DEVICE TOO FULL
DEVICE TOO FULL
DEVICE TOO FULL
The machine is equipped with a float, which intervenes when the recovery tank is full. Its
intervention causes the closing of the suction hose. In this case, it is necessary to
proceed with the emptying of the recovery tank taking off the plug of the exhaust hose.
RECYCLING OF THE CLEANING SOLUTION
RECYCLING OF THE CLEANING SOLUTION
RECYCLING OF THE CLEANING SOLUTION
RECYCLING OF THE CLEANING SOLUTION
If the machine is equipped with a recycling system of the cleaning solution,
for its use refer to the instructions given with the device. In any case, it is
necessary to pay attention to the following recommendations:
the use of the recycling system must be limited to the cleaning of environments
•
not excessively dirty
avoid absolutely to treat environments not homogeneous for use and typology of
•
dirt or anyhow separated between each other
normally, the treated surface does not have to exceed twice as much of the one
•
treated without recycling
remember that the detergent efficacy progressively gets exhausted and it is
•
absolutely not recommended to make additions in the dirty solution
clean thoroughly the filters and the tanks at the end of the work
•
PERFORMANCE
PERFORMANCE
PERFORMANCE
PERFORMANCE
41