Sabo 72-12 HF Manual Del Operador página 46

4
EN
will not be regained by the application of the
brake.
The main reasons for loss of control are:
– insufficient wheel grip;
– being driven too fast;
– inadequate braking;
– the type of machine is unsuitable for its task;
– lack of awareness of the effect of ground
conditions, especially slopes;
8) The machine is equipped with a series of
safety microswitches and devices which must
never be removed, altered or tampered with.
Removing these devices invalidates the war-
ranty and the manufacturer declines any re-
sponsibility.
B) PREPARATION
1) While mowing, always wear substantial
footwear and long trousers. Do not operate the
equipment when barefoot or wearing open
sandals.
2) Thoroughly inspect the area where the
equipment is to be used and remove all ob-
jects which may be thrown by the machine
(stones, sticks, metal wire, bones, etc.)
3) WARNING: DANGER! - Engine fuel is highly
flammable:
– store fuel in containers specifically designed
for this purpose;
– refuel using a funnel and outdoors only. Do
not smoke while refuelling or whenever han-
dling the fuel;
– add fuel before starting the engine. Never
remove the cap of the fuel tank or add fuel
while the engine is running or when the en-
gine is hot;
– if fuel is spilled, do not attempt to start the
engine but move the machine away from the
area of spillage and avoid creating any source
of ignition until the fuel has evaporated and the
fumes dispersed;
– replace caps of all fuel tanks and containers
securely.
4) Replace faulty silencers.
5) Before using, always carry out a visual in-
spection, particularly of the blade, seeing that
the screws and cutter assembly are not worn
or damaged. Replace a worn or damaged
blade and screws as a set to preserve balance.
6) Before mowing, attach the discharge open-
ing guards (grass-catcher or stone-guard).
C) OPERATION
1) Do not operate the engine in a confined
space where dangerous carbon monoxide
fumes can collect.
2) Mow only in daylight or good artificial light.
3) Avoid operating the equipment in wet
grass, where feasible.
4) Before starting the engine, disengage the
blade, shift the gear lever (
drive models) or the speed change lever
( for hydrostatic drive models) into neutral
and engage the parking brake.
5) Do not use on slopes of more than 10°
(17%).
6) Remember there is no such thing as a
"safe" slope. Travel on grass slopes requires
particular care. To guard against overturning:
– it is advisable to use a front counterweight
(supplied on request);
– do not stop or start suddenly when going up
or downhill;
– engage clutch slowly, always keep the ma-
chine in gear (
els) or engage the speed change lever slow-
ly both for forward and reverse movement
( for hydrostatic drive models), especially
when travelling downhill;
– machine speeds should be kept low on
slopes and during tight turns;
– stay alert for humps and hollows and other
hidden hazards;
– never mow across the face of the slope.
7) Stop the blade rotating and put the cutting
deck into the highest position before crossing
surfaces other than grass.
8) Never use the machine to cut grass if the
guards are defective, or without the stone-
guard and/or grass-catcher in place.
9) Do not change the engine governor settings
or overspeed the engine.
SAFETY
for mechanical
for mechanical drive mod-