Interventions On The Machine - Sabo 72-12 HF Manual Del Operador

32
EN
6.3.2 Rear axle
These are permanently lubricated with grease that does not need changing.
6.3.3 Battery
To ensure long life to the battery it is essential to keep it carefully maintained.
The machine battery must always be charged:
– before using the machine for the first time after purchase;
– before leaving the machine for a prolonged pe-
riod of disuse;
– before starting up the machine after a pro-
longed period of disuse.
– Carefully read and comply with the procedure
for recharging described in the booklet coming
with the battery. If the procedure is not fol-
lowed or the battery is not charged, irreparable
damage could be caused to the elements in-
side the battery.
– A flat battery must be recharged as soon as
possible.
IMPORTANT
voltage. Other recharging systems can irreversibly damage the battery.
The machine has a connector (1) for recharging, to be connected to the corresponding
connector of the special "CB01" maintenance battery-charger supplied (
or available on request (
IMPORTANT
maintenance battery-charger. For its use:
– follow the instructions given in the relative instruction booklet,
– follow the instructions given in the battery booklet.

6.4 INTERVENTIONS ON THE MACHINE

6.4.1 Cutting deck alignment
The cutting deck should be properly set to obtain a good cut.
If the cut is uneven, check the tyre pressure.
Recharging must be done using a battery charger at constant
9).
This connector must only be used for connection to the "CB01"
MAINTENANCE
1
if included)