Sony DR-BT22iK Manual De Instrucciones página 22

5
Press and hold the power button of the transmitter for about 7
seconds or more to enter "Pairing in process."
Aft er about 1 second, the transmitter indicator will fl ash twice,
but keep pressing the power button.
Notes
 When fi rst power on the transmitter aft er initialized, the transmitter will enter "Pairing
in process" automatically.
 Th e pairing information is initialized if you press and hold the power button for 15
seconds. Th e transmitter indicator lights up for 5 seconds before the initialization
starts. Release the button immediately when the transmitter indicator lights up.
When the transmitter indicator fl ashes quickly, stop pressing.
Th e transmitter enters "Pairing in process. "
Th e transmitter indicator status will vary as follows, and pairing
is established with the Bluetooth receiving device.
Th e transmitter indicator fl ashes quickly: Pairing in process
Th e transmitter indicator fl ashes (at about 1-second intervals)
when responding to the Bluetooth receiving device: Connectable
(Pairing successful)
Th e transmitter indicator fl ashes (at about 5-second intervals):
Connected
Notes
 "Pairing in process" of the transmitter is released aft er about 5 minutes. If pairing is
not established within about 5 minutes, repeat the above procedure from step 4. iPod
backlight may turn on in this 5 minutes.
 To enter "Pairing in process," you need to turn off the power of the transmitter fi rst.
When not completed pairing
Repeat the procedure from step 2.
To quit "Pairing in process"
Press and hold the power button of the transmitter for about 1 second to turn off
the transmitter.
22 GB

